
A renovation isn’t one plumbing job, it’s two, done weeks apart. The first happens early, while the room is stripped back to studs and slab. The second happens near the end, once the tiler and cabinet maker have finished their work.
Get the first stage wrong and you won’t find out until the second, by which point the tiles are down and fixing it means pulling them back up.
Two stages, done weeks apart, plus the kitchen’s own set of connections.
New water and drainage lines run to match your renovation plan, positioned exactly where each new fixture will sit, then pressure tested before anything gets covered.
Toilet, vanity, shower mixer, bath, tapware and freestanding fixtures connected once tiling and cabinetry are finished, then tested under normal water pressure.
Sink and mixer tap, dishwasher water supply and a properly trapped waste connection, and a water filtration tap if you’re adding one.
Most renovation delays come from trades not talking to each other. We coordinate directly with your builder or project manager so the rough-in lands at the right point in the build sequence, and fit-off doesn’t get held up waiting on us, or held up by us waiting on someone else.
Renovation plumbing gets scoped as one job covering rough-in and fit-off together, so you get a single quote rather than two separate guesses along the way.

We take on renovation plumbing across Sydney, including Hurstville and Sutherland Shire.
If your job is smaller in scope, say a tap or toilet swap without moving any pipework, our Toilet & Tap Repairs page covers that more directly.
Or call 0413 382 125

Privacy Policy | Terms & Conditions